2.4G Customized remote control with PCBA receiver

2 : Normal function of remote control

The remote control interface includes 13 keys and 1 indicator lamp. The operation and

Instructions are as follows: press the key button, the indicator light starts, the indicator

 light goes out after release;

3: pair

Pair: after the engine is opened to insert the USB receiver, the remote control is close to the USB receiver 30CM and presses the "VOL+" + "VOL-" key for 3 seconds LED to flicker the button and enters the pairing mode; the paired successful LED is turned out for 2 seconds and then goes out.

Note: the factory remote controller and the USB receiver have been paired by default.

4: Mouse switch

1 > Mouse open: when the mouse is closed, click "mouse" button to open the mouse.

2 > left mouse button: when the mouse is open, click "OK" key. Button response to the left 

mouse button function.

3 > mouse closed: when the mouse opened, click the mouse button to close the mouse.

Note: reboot and sleep wake up after the mouse default closed state!

5: Dormancy mode and wake-up

1 >. Normal mode: key release remote into sleep mode.　

2 >. Mouse mode: 1 min without sloshing or button operation, remote control into sleep

mode.

Note: when the remote controller is in hibernation mode, it can be woken up by pressing

any key

6: Phonetic function

Long press the "voice" button, open voice pick-up, light long light, when loosened, turn off

the sound, the light goes out.

7: Low voltage detection

When the voltage of the power supply is lower than 2.3 V, press the key LED to flash 20

seconds will appear.